View NC7SZ6605_1287614.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

NC7SZ66 Low Voltage Single SPST Normally Open Bus Switch
November 1996 Revised December 2005
NC7SZ66 Low Voltage Single SPST Normally Open Bus Switch
General Description
The NC7SZ66 is a ultra high-speed (UHS) CMOS compatible single-pole/single-throw (SPST) bus switch. The LOW On Resistance of the switch allows inputs to be connected to outputs with minimal propagation delay and without generating additional ground bounce noise. The device is organized as a 1bit switch with a switch enable (OE) signal. When OE is HIGH, the switch is on and Port A is connected to Port B. When OE is LOW, the switch is open and a high-impedance state exists between the two ports.
Features O Space saving SOT23 or SC70 5-lead package O Ultra small MicroPak Pb-Free leadless package O Broad VCC Operating Range 1.65V-5.5V O Rail-to-rail signal handling O 5: switch connection between two ports O Minimal propagation delay through the switch O Low ICC O Zero bounce in flow-through mode O Control input compatible with CMOS input levels
Ordering Code:
Order Number
NC7SZ66M5X NC7SZ66P5X NC7SZ66L6X
Package Number
MA05B MAA05A MAC06
Product Code Top Mark
7Z66 Z66 EE
Package Description
5-Lead SOT23, JEDEC MO-178, 1.6mm Pb-Free 6-Lead MicroPak, 1.0mm Wide
Supplied As
3k Units on Tape and Reel 5k Units on Tape and Reel
5-Lead SC70, EIAJ SC-88a, 1.25mm Wide 3k Units on Tape and Reel
Pb-Free package per JEDEC J-STD-020B.
MicroPak is a trademark of Fairchild Semiconductor Corporation.
(c) 2005 Fairchild Semiconductor Corporation
DS012177
www.fairchildsemi.com
NC7SZ66
Logic Symbol
Connection Diagrams
Pin Assignments for SC70
(Top View)
Pin Descriptions
Pin Names
OE A B NC
Pad Assignment for MicroPak
Description
Switch Enable Input Bus A I/O Bus B I/O No Connect
Function Table
(Top Through View)
OE
L H
B0
HIGH-Z State A0
Function
Disconnect Connect
www.fairchildsemi.com
2
NC7SZ66
Absolute Maximum Ratings(Note 1)
Supply Voltage (VCC) DC Switch Voltage (VS) DC Input Voltage (VIN) (Note 2) DC Input Diode Current (IIK) VIN 0V DC Output (IOUT) Sink Current DC VCC/GND Current (ICC/IGND) Storage Temperature Range (TSTG) Junction Lead Temperature under Bias (TJ) Junction Lead Temperature (TL) Power Dissipation (PD) @ 85qC SOT23-5 SC70-5 (Soldering, 10 Seconds)
0.5V to 7.0V 0.5V to VCC 0.5V 0.5V to 7.0V 50 mA r100 mA 65qC to 150qC 150qC 260qC
200 mW 150 mW 128 mA
Recommended Operating Conditions (Note 3)
Power Supply Operating (VCC) Control Input Voltage (VIN) Switch Input Voltage (VIN) Switch Output Voltage (VOUT) Input Rise and Fall Time (tr, tf) Control Input; VCC Control Input; VCC Switch I/O Operating Temperature (TA) Thermal Resistance (TJA) SOT23-5 SC70-5 300qC/Watt 425qC/Watt 2.3V3.6V 4.55.5V 0 ns/V to 10 ns 0 ns/V to 5 ns 0 ns/V to DC 1.65V to 5.5V 0V to 5.5V 0V to VCC 0V to VCC
40qC to 85qC
Note 1: The "Absolute Maximum Ratings" are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum ratings. The "Recommended Operating Conditions" table will define the conditions for actual device operation. Note 2: The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. Note 3: Unused inputs must be held HIGH or LOW. They may not float.
DC Electrical Characteristics
VCC Symbol VIH VIL IIN IOFF RON Parameter HIGH Level Input Voltage LOW Level Input Voltage Control Input Leakage Current OFF Leakage Current Switch On Resistance (Note 4) 4.5 (V) 1.65 to 1.95 2.3 to 5.5 1.65 to 1.95 2.3 to 5.5 0 to 5.5 1.65 to 5.5 Min 0.75 VCC 0.7 VCC 0.25 VCC 0.3 VCC TA
40qC to 85qC
Typ (Note 5) Max Min
TA
25qC
Typ Max Units Conditions
V V
r0.05 r0.05
3.0 5.0 7.0 4.0 10.0 5.0 13.0 7.0 25.0
r1.0 r10.0
7.0 12.0 15.0 9.0 20.0 12.0 30.0 28.0 60.0 6.0 12.0 28.0 125
PA PA
0 d VIN d 5.5V 0 d A, B d VCC VIN VIN VIN VIN VIN VIN VIN VIN VIN IA 0V, IIN 2.4V, IIN 4.5V, IIN 0V, IIN 3V, IIN 0V, IIN 2.3V, IIN 0V, IIN 1.8V, IIN 30 mA 15 mA 30 mA 24 mA 24 mA 8 mA 8 mA 4 mA 4 mA
3.0 2.3 1.8 Rflat On Resistance Flatness (Note 4)(Note 6)(Note 7) 5.0 3.3 2.5 1.8 ICC Quiescent Supply Current 1.65 to 5.5
:
: PA
IA IA IA VIN
30 mA, 0 d VBn d VCC 24 mA, 0 d VBn d VCC 8 mA, 0 d VBn d VCC 4 mA, 0 d VBn d VCC
VCC or GND 0
0.05
10.0
IOUT
Note 4: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the voltages on the two (A or B) pins. Note 5: All typical values are at the specified VCC, and TA 25qC.
Note 6: Parameter is characterized but not tested in production. Note 7: Flatness is defined as the difference between the maximum and minimum value of On Resistance over the specified range of conditions.
3
www.fairchildsemi.com
NC7SZ66
AC Electrical Characteristics
TA Symbol Parameter VCC (V) tPHL, tPLH Propagation Delay Bus to Bus (Note 9) 1.65 to 1.95 2.3-2.7 3.0-3.6 4.5-5.5 tPZL, tPZH Output Enable Time 1.65 to 1.95 2.3-2.7 3.0-3.6 4.5-5.5 tPLZ, tPHZ Output Disable Time 1.65 to 1.95 2.3-2.7 3.0-3.6 4.5-5.5 Note 8: All typical values are at the specified VCC, and TA 25qC. 1.5 1.5 1.5 1.5 1.5 1.5 1.5 1.5 7.0 3.3 2.4 2.0 9.2 5.3 4.0 2.7
40qC to 85qC,
RD 500: Max 4.3 1.2 0.8 0.3 14.2 7.0 5.5 4.5 18.2 9.0 7.0 5.0 ns ns ns VIN 2 x VCC for tPLZ VIN 0V for tPHZ Figures 1Figure 2 ns ns ns VIN VIN 2 x VCC for tPZL 0V for tPZH Figures 1, 2 ns ns ns VIN OPEN Figures 1, 2 Units Conditions Figure Number Typ (Note 8)
CL 50 pF, RU Min
Note 9: This parameter is guaranteed by design but is not tested. The switch contributes no propagation delay other than the RC delay of the typical On Resistance of the switch and the 50 pF load capacitance, when driven by an ideal voltage source (zero output impedance).
Capacitance
Symbol CIN CI/O Parameter Control Pin Input Capacitance Input/Output Capacitance Typ 2 6 Max Units pF pF Conditions VCC VCC 0V 5.0V
AC Loading and Waveforms
Input driven by 50: source terminated in 50: CL includes load and stray capacitance. Input PRR 1.0 MHz; tw 500 ns
FIGURE 1. AC Test Circuit
FIGURE 2. AC Waveforms
www.fairchildsemi.com
4
NC7SZ66
Tape and Reel Specification
TAPE FORMAT for SOT23 and SC70
Package Designator
M5X, P5X
Tape Section
Leader (Start End) Carrier Trailer (Hub End)
Number Cavities
125 (typ) 3000 75 (typ)
Cavity Status
Empty Filled Empty
Cover Tape Status
Sealed Sealed Sealed
TAPE DIMENSIONS inches (millimeters)
Package
SC70-5 SOT23-5
Tape Size
8 mm 8 mm
DIM A
0.093 (2.35) 0.130 (3.3)
DIM B
0.096 (2.45) 0.130 (3.3)
DIM F
0.138 r 0.004 0.138 r 0.002 (3.5 r 0.05) (3.5 r 0.10)
0.053 r 0.004 0.055 r 0.004 (1.4 r 0.11) (1.35 r 0.10)
DIM Ko
DIM P1
0.157 (4) 0.157 (4)
DIM W
0.315 r 0.004 0.315 r 0.012 (8 r 0.3) (8 r 0.1)
5
www.fairchildsemi.com
NC7SZ66
TAPE FORMAT for MicroPak
Package Designator
L6X
Tape Section
Leader (Start End) Carrier Trailer (Hub End)
Number Cavities
125 (typ) 5000 75 (typ)
Cavity Status
Empty Filled Empty
Cover Tape Status
Sealed Sealed Sealed
TAPE DIMENSIONS inches (millimeters)
REEL DIMENSIONS inches (millimeters)
Tape Size
8 mm
A
7.0 (177.8)
B
0.059 (1.50)
C
0.512 (13.00)
D
0.795 (20.20)
N
2.165 (55.00)
0.331 0.059/0.000 (8.40 1.50/0.00)
W1
W2
0.567 (14.40)
W1 0.078/0.039 (W1 2.00/1.00)
W3
www.fairchildsemi.com
6
NC7SZ66
Physical Dimensions inches (millimeters) unless otherwise noted
5-Lead SOT23, JEDEC MO-178, 1.6mm Package Number MA05B
7
www.fairchildsemi.com
NC7SZ66
Physical Dimensions inches (millimeters) unless otherwise noted (Continued)
5-Lead SC70, EIAJ SC-88a, 1.25mm Wide Package Number MAA05A
www.fairchildsemi.com
8
NC7SZ66
Physical Dimensions inches (millimeters) unless otherwise noted (Continued)
Pb-Free 6-Lead MicroPak, 1.0mm Wide Package Number MAC06A
9
www.fairchildsemi.com
NC7SZ66 Low Voltage Single SPST Normally Open Bus Switch
DISCLAIMER
FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS.
LIFE SUPPORT POLICY
FAIRCHILD'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION As used herein: provided in the labeling, can be reasonably expected to result in significant injury to the user. 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or 2. A critical component is any component of a life support (b) support or sustain life, or (c) whose failure to perform device or system whose failure to perform can be reasonwhen properly used in accordance with instructions for use ably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness.
PRODUCT STATUS DEFINITIONS
Definition of terms
Datasheet Identification Product Status
Advance Information Preliminary Formative or In Design First Production
Definition
This datasheet contains the design specifications for product development. Specifications may change in any manner without notice. This datasheet contains preliminary data, and supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. This datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. This datasheet contains specifications on a product that has been discontinued by Fairchild Semiconductor. The datasheet is printed for reference information only.
No Identification Needed
Full Production
Obsolete
Not In Production
www.fairchildsemi.com
10

▲Up To Search▲

Price & Availability of NC7SZ6605

	To Download NC7SZ6605 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .